This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Tinypilot tiller master
#1
I finally completed the initial setup. I am using an rpi3b as my plotter and Sean’s weather sensor, motor controller and pi zero running tiny pilot. I wired in a switch so I could easily revert back to the built in controls in the tiller master if I had a system crash. The gps and ais resides on the rpi 3 and the rest of the sensors are hooked to the zero. This allows me to sail apparent wind and magnetic heading without out firing up the plotter. However is I do all sensors talk via the A.P. built into the zero. Which allows me to also sail to a plotted course and gps/true wind settings. [Image: 4bfd1a339aba62e90f93355119269faa.jpg][Image: 58cc14ab1ba0e34ead311cceef74e4a7.jpg][Image: d90bb02ce80150485c9f3bae9568eed6.jpg][Image: 0cb14a6df41e2a6136586b493c862f89.jpg][Image: 68cee7b11df1278d0bc46d37e07575f1.jpg]


Sent from my iPhone using Tapatalk
  Reply
#2
Awesome!!! thanks for sharing
  Reply
#3
(04-24-2019, 03:22 PM)Sailoog Wrote: Awesome!!! thanks for sharing


Accept now I sold the boat and have to come up with a non tiller set up of some sort.


Sent from my iPhone using Tapatalk
  Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)